PRICES 7/20/08
"SUPER BOX" UPPER INTAKES $ 325.00 METAL
$395.00 ALUMINUM
These are made for any lower you may have from stock to ELDERBROCK,HOLLEY ,COBRA ECT..... They make 25-45HP over stock intake upper They will make awsome power with a TURBO or SUPER CHARGER ! They make 5-20 more torgue over stock and take off 3-4.5 tenth's in the 1/8th mile ... But this all depends on what you have done to your motor.
4.6 and 5.4 2V and DOHC intakes
$600.00 and up CARB
$750.00 and up EFI
These intake can be made for either Carb or EFI can make about 50HP and up over a stock intake in carb form . EFI should make awsome HP with a Turbo or Supercharger. I can make these intakes any way you want , With short or long runners with single or 2-4's carb , any size plentum's with any T/B FLANGES Cobra , 5.0 or any style and any size, Just ask.
Bolt on DISTRIBUTORS for 4.6 and 5.4 motors
I use new Distributors only. They are GM type Distributors but they turn in the right direction. You can't even tell there GM.
.I now offer a intercooler intake for turbo's and superchargers
They are aluminum 6061 billet. water to air inter coolers with 80mm TB..can handle up to 1000hp! $800.00+$20.00 shipping can make them for mustang lower intakes any you may have.. I can also make them for 4 cyl Honda's to Toyata's , or any other motor out there .
FRP RACING FRP RACING FRP RACING FRP RACING FRP RACING FRP RACING FRP RACING FRP RACING FRP RACINGF RP RACING
FRP RACING FRP RACING FRP RACING FRP RACING FRP RACING FRP RACING FRP RACING FRP RACING FRP RACING FRP RACING
FRP Racing
Custom sheet metal
Intakes
You get the GM type of distributor (NEW) cut down , and mounting block, hold down ect... For $350.00
You have a distributor?? I can cut it down and make a kit for it for $250.00+ $15.00 shipping
